Radio Reception
English
To stop storing the automatic preset � Press PROGRAM or � on the system. Note: � If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden. Manual Preset Programming
Erasing a preset radio station 1 2
Press à or ë to select the preset radio station to be erased. Press and hold �on the system until �PRESET DELETED� is displayed. � The deleted radio frequency remains on the display. � The preset numbers of all other preset radio stations in the band with higher numbers are also decreased by one.
1 2
Tune to your desired radio station (refer to �Tuning to radio stations�). Press PROGRAM. � PROG starts flashing.
� Repeat steps 1�2 to erase other preset radio stations.
� The next available preset number is displayed for selection. To store the radio station to another preset number � Press à or ë to select the desired preset number.
For Recording, please refer to �Tape Operation/Recording�.
3
Press PROGRAM again to store the radio station. � PROG disappears.
Changing tuning grid (not available for
all versions) In North and South America, the frequency step between adjacent channels in the MW band is 10 kHz (9 kHz in some areas). The preset frequency step in the factory is 9 kHz. Changing the tuning grid will erase all previously stored preset radio stations.
� Repeat steps 1�3 to store other radio stations. To exit manual preset mode � Press � on the system. Notes: � If you attempt to store more than 40 preset radio stations, "FULL" is displayed. � During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically.
1 2
Disconnect the system from the AC power supply (pull out the AC power cord). While holding down TUNER and á on the system, reconnect the system to the AC power supply. � The display will show "GRID 9" or "GRID 10". Notes: � GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively. � The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa.
Tuning to preset radio stations
� Once you�ve programmed the radio stations, press à or ë to select the desired preset number. � The preset number, radio frequency, and waveband are displayed.