Preparations
IMPORTANT! � Make sure to complete the preparation procedures before operating the system.
Step 2: Setting the clock
The clock can be set in either 12-hour or 24hour mode (�PM 00:00� or �00:00� for example).
Step 1: Inserting batteries into the remote control
3 1 2
1
The clock can be set in any source mode. � If you have not set the clock, �--:--� will be shown on the display.
1 2 3
2
Open the battery compartment. Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by �+� and ��� symbols. Close the cover. Using the remote control to operate the system
Press and hold CLOCK/TIMER until �SELECT CLOCK OR TIMER� is displayed. � Press O or P to change the display to �CLOCK�. � Press CLOCK/TIMER again to confirm. Press O or P on the system to set the hours. Press 1 or ¡ on the system to set the minutes. Press CLOCK/TIMER to confirm your setting. The system will store the setting automatically and go back to it�s previous status. � The time setting becomes effective. Note: � In AUX mode, setting clock using remote control is not possible. To exit the setting without storing (in
3 4 5
1 2
Point the remote control directly at the remote sensor (IR) on the front panel. Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TAPE1/2, TUNER).
3
Then select the desired function (for example 2;, O or P).
CAUTION! � Remove batteries if they are exhausted or will not be used for a long time. � Do not use old and new or different types of batteries in combination. � Batteries contain chemical substances, so they should be disposed of properly.
standby mode) � Press 9 on the system to exit. � �CANCEL� will appear on the display. � Press STANDBY ON to exit setting mode and go into POWER ON mode. � You can also press DISC, DISC1~3, DISC CHANGE, OPEN/CLOSE to exit setting mode and go into disc mode. � The system will also exit setting mode and go to TUNER, TAPE or AUX mode when you press the corresponding source button. Viewing the clock in any source mode � When you have set the clock, press CLOCK/ TIMER to view clock. Press DISPLAY on the system to toggle between 12-hour and 24-hour modes. � The time will be displayed for 5 seconds and then go back to it�s previous status. 19
