PHILIPS FWC500
Manual de Usuario

Clock/Timer
2
Press CD, TUNER or TAPE to select the desired source. G Make sure the music source has been prepared. CD � Load the disc(s). To start from a specific track, make a program (refer to �CD Operation Programming the disc tracks�). TUNER � tune to the desired radio station. TAPE � load the prerecorded tape into tape deck 2. 3 Press à or á on the system repeatedly to set the hour for the timer to start. 4 Press í or ë on the system repeatedly to set the minute for the timer to start. 5 Press CLOCK�TIMER to store the start time. � "TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source. � TIMER will remain on the display. G At the preset time, the selected source will play. To exit without storing the setting G Press �on the system. Notes: � If the selected source (CD or TAPE) is not available when preset timer is reached, TUNER will be selected automatically. � During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. To deactivate the TIMER G Press TIMER ON/OFF on the remote control. � The display will show "CANCEL" and TIMER will disappear from the display. To activate the TIMER G Press TIMER ON/OFF on the remote control. � The last set timer information will be shown for a few seconds and TIMER will appear on the display.

Sleep Timer Setting
The sleep timer enables the system to switch to Standby mode automatically at a preset time.

E n g l i s h

1

2

Press SLEEP on the remote control repeatedly to select a preset time. � The selections are as follows (time in minutes): 15 � 30 � 45 � 60 � OFF � 15 � � "SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes. When you reach the desired length of time, stop pressing the SLEEP button. � SLEEP will appear on the display, except for "OFF" mode. � The Sleep Timer is now set. Before the system switches to standby mode, a countdown of 10 seconds will be displayed. "SLEEP 10" � "SLEEP 9".... � "SLEEP 1" � "SLEEP" While SLEEP mode is activated

To check the remaining length of time G Press SLEEP once. To change the preset sleep timer G Press SLEEP twice. � The display will show the remaining time followed by the sequence of sleep timer options. To deactivate the Sleep Timer G Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.

26
pg 001-030/C500-C550/37-Eng 26 12/8/00, 1:58 PM

3139 115 20561