SHARP FU60SEK
Manual de Usuario

PREPARATION
INSERTING BATTERIES IN THE REMOTE CONTROL

1 2 3

Remove the back cover
Press and slide the back cover to remove.

Insert batteries
Insert batteries with shown below. and as

Close the back cover

About the batteries
� The battery life is about 1 year. � Replace the batteries when the remote control becomes inoperative. � Incorrect usage of the batteries may cause battery fluid leakage and/or damage. Take care of the following when handling: � When replacing the batteries, replace both batteries with new ones of the same type. (Use R6(AA) manganese batteries (2 units).) � When not using the unit or remote control for an extended period, remove the batteries. This prevents malfunction of the remote control from battery fluid leakage. *The batteries of the accessory are for initial use only and may be depleted within 1 year.

USING THE REMOTE CONTROL
� Operate the remote control facing the main unit (Receiver). � The signal range is about 7m (front). � Make sure there are no objects blocking the path of the signal.
Receiver Transmitter

NOTE
� Avoid strong impact on the remote control. In addition, do not wet the remote control or place it under direct sunlight or near a stove, etc., otherwise a malfunction may occur.

E-7