INSTALLATION INSTRUCTIONS SWIVEL BASE To attach the swivel base to the monitor, do the following: � Carefully turn the monitor on its side or upside down. (see figure 1) � Locate the cavities at the bottom front of the monitor. � Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. � To remove the swivel base, hold the bottom of the swivel base, then push it out. POWER CORD Power Source: 1. Make sure the power cord is the correct type that required in your area. 2. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required). 3. Connect the power cord into your monitor�s power input socket, and then plug the other end into a 3-pin AC power outlet. The power cord may be connected to either a wall power outlet or the power outlet socket on your PC, depending on the type of power cord supplied with your monitor. VIDEO CABLE Connecting the Video Cable: the monitor comes with a built-in video cable. Plug the signal cable�s 15-pin connector into the computer's video port and tighten the two screws on the cable connector. (see figure 2) Caution: Don�t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power socket. Then plug the power cord into a grounded AC outlet or UL-approved power strip or the power output socket on your PC. Caution: If the AC outlet is not grounded, install the proper grounding adapter (not supplied).