JBL FSN26
Manual de Usuario

FSN24,26 OM

12/8/99

2:01 PM

Page 2

WIRE HOOKUP
�Fish� the speaker wire through the stand posts and bring it out through the round hole on the coneshaped fitting.

AT TA C H S P E A K E R
1. While looking at the top of the stand, turn the �knurled� nut (a) that is installed on top of the threaded shaft (b), by hand clockwise, until it is seated against the top of the stand post (c). 2. Place the speaker on top of the stand, with its standattachment hole on the bottom aligned with the stand�s threaded shaft (b). Be careful when starting the threads to avoid crossthreading (misaligning the threads � see Step 3); cross-threading may damage the speaker and/or the stand. 3. Once the threads are properly aligned and engaged (if the threads are not properly engaged, the speaker will not easily rotate on the shaft), turn the speaker clockwise (while looking at the top of the speaker) 8 to 10 turns. The speaker should by then be securely attached to the stand post. Make sure that the speaker grille is facing forward.
e d
JBL Consumer Products 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 800-336-4JBL (4525) (USA only) www.jbl.com ©1999 JBL, Incorporated. JBL is a registered trademark of JBL, Incorporated. Part No. FSN24/FSN26 O/G

4. Using a suitable wrench (not included), securely tighten the �knurled� nut (a) up against the bottom of the speaker until the floorstand post and the speaker are fully locked together, so that neither can be rotated by hand. 5. Pull the cone-shaped fitting (d) up against the speaker bottom, with its speaker wire hole (e) toward the back. 6. Connect the speaker wires to the speaker as outlined in the speaker�s owner�s manual.

a b c

PRO SOUND COMES HOME�