JVC FS-H100
Manual de Usuario

Using the Timers
Daily Timer and Sleep Timer are available. � Before using these timers, make sure the built-in clock is set correctly (see page 8).

Continued

3 Press SET to set the on-time you want
the unit to turn on.
The hour indication starts flashing on the display.
1

SET

Using the Daily Timer
You can store three Daily timer settings and use one of settings at once.

How the Daily Timer actually works
When the on-time comes, the unit automatically turns on and automatically turns off (standby) after 60 minutes. � Once the timer has been set, it will be activated at the same time everyday until the timer is turned off and the timer setting remains in memory until you change it.

(1) Press ¢ or 4 to set the hour, then press SET. SET (2) Press ¢ or 4 to set the minute, then press SET. If you want to change the time setting, press CANCEL.

Before you start...
When using �TUNER� as the source to play, make sure to select the desired station before turning off the power. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 2.

4 Press ¢ or 4 to select the
source to play.
1

On the remote control ONLY:

Each time you press the button, the source changes as follows:
STANDBY/ON

1 Press STANDBY/ON
the unit.

to turn on

TUNER

CD

AUX

2 Press CLOCK/TIMER repeatedly to
select the Daily Timer you want to adjust and activate� Daily 1, Daily 2, Daily 3.

CLOCK/ TIMER

When selecting AUX, prepare the external equipment so that it will turn on at the on time set-on the unit. To allow this, the equipment should have the timer function. If you want to change the time setting, press CANCEL repeatedly to return Step 3.

Each time you press the button, the display changes as follows: 1
Daily 1 Timer

5 Press SET.
The Daily Timer number remain lit. The display return to the normal indication.

SET

6 Press VOLUME +/� to adjust the
volume.
2

VOLUME

Daily 2 Timer

7 Press STANDBY/ON
the unit.
3

to turn off

STANDBY/ON

Daily 3 Timer

Present time indication Normal indication

If you does not need to change the on-time setting, go to step 3.

19