SHARP FO-5900SE
Manual de Servicio

FO-5900SE FO-5900DE
Loading paper in the paper cassette (if installed FO-59A4)
stops.

1Grasp the hand-hold on the cassette and pull the cassette out until it

5. Clearing paper jams

Clearing a jammed document

If the original document doesn�t feed properly during transmission or copying, or REMOVE ORIGINAL(S) appears in the display, fist try pressing START/ . If the document doesn�t feed out, open the operation panel ENTER and remove it. Important: Do not try to remove a document without opening the operation panel. This may damage the feeder mechanism.

1Open the operation panel.
� Squeeze the release marked PANEL RELEASE and pull up.

2Push the pressure plate down until it locks into position.

3Squeeze the paper guide and pull up to move it to the appropriate
holes for the length of the paper. Push the guide down into the holes.
1 2

2Remove the document.

4Place a stack of paper in the cassette, print side up.
� Make sure the stack of paper is not higher than the two tabs on the
paper guide and the two metal tabs. If it is, remove some of the paper. � If you find it difficult to load the paper, remove the cassette from the machine. (Pull the cassette out as far as it will go, grasp the left side of the cassette with your left hand, and then lift it up and out with both hands.)

3Close the operation panel, making sure it clicks into place.

5Push the cassette back into the machine, making sure it clicks into
place.

1�7