|
Usuarios conectados
Actualmente hay 6037 visitantes y 3 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
FO-3150DE/IT/SE
[5] Maintenance
1. Scanning glass and rollers.
Clean the scanning glass and rollers frequently to ensure that your transmitted images and copies are of the highest quality. Open the operation panel (grasp the panel release and up), and wipe the scanning glass, rollers and white backplate with a soft cloth. � Make sure that all dirt and stains (such as correcting fluid) are removed, as dirts and stains will cause vertical lines on transmitted images and copies.
3. Cleaning the drum cartridge.
If you find that characters or parts of an image are missing from your printed pages, the drum in the drum cartridge may need cleaning. Follow the steps below to clean the drum. 1. Grasp the print compartment cover at both sides as shown, and pull up to open the cover. � Caution! The fusing unit inside the print compartment becomes very hot during operation. Do not touch the inside of the compartment or the paper guide on the underside of the print compartment cover.
1. Squeeze the panel release and open the operation panel.
2. Wipe the scanning glass (under the white roller) and rollers with a cotton swab. � Make sure that all dirt and stains (such as correcting fluied) are removed. Dirt and stains will cause vertical lines on transmitted images and copies.
2. Grasp the finger hold on the toner cartridge handle where it is marked PUSH, and pull the handle out. Rehold the handle and pull the toner cartridge out of the compartment. � Place the toner cartridge on a sheet of paper on a level surface.
Document rollers
White backplate Scanning glass
If the scanning glass is difficult to clean If you find it difficult to remove dirt from the scanning glass, you can try moistening the swab with isopropyl alchol or denatured alcohol. Take care that no alcohol gets on the rollers. 3. Close the operation panel.
3. Grasp the tabs on the drum cartridge handle with both hands and gently pull the cartridge out of the machine.
2. The housing.
Wipe the external parts and surface of the machine with a dry cloth. � Caution! Do not use benzene or thinner. These solvents may damage or discolor the machine.
4. Take a sheet of clean paper and roll it into a tube. Roll it tightly so that the diameter of the holes at each end is less than the thickness of your little finger.
1 � 11
|
|
|
> |
|