PIONEER FH-P9200MP/ES
Manual de Usuario

Section

Audio Adjustments

11

M HPF: 31.540506380100125 160200 (Hz) M LPF: 1.622.53.15456.38 1012.516 (kHz) H HPF: 1.622.53.15456.38 1012.516 (kHz) 4 Press a or b to adjust the level of the selected speaker unit (filter). Each press of a or b increases or decreases the level of the selected speaker unit (filter). 0dB  24dB is displayed as the levelis increased or decreased. +6dB  24dB is displayed as the levelis increased or decreased, only if you haveselected L LPF. 5 Press SLOPE to select the slope of the selected speaker unit (filter). L LPF: 12 18 6 (dB/oct.) M HPF: 12 18Pass (0) 6 (dB/oct.) M LPF: 12Pass (0) 6 (dB/oct.) H HPF: 12 6 (dB/oct.) 6 Press PHASE to switch the phase of the selected speaker unit (filter). Each press of PHASE switches the phase between normal and reverse .
# You can adjust the parameters for other speaker units (filters) in the same way.

# SW2 is displayed only when the subwoofer output is on in the subwoofer output mode (SW1).

1 Press AUDIO and NEXT and then press SW1 to select the subwoofer output mode.

# To turn subwoofer output off, press SW1 again.

2 Press SW1 to turn subwoofer output on. SUB.W ON appears in the display. Subwoofer output is now on.

3 Press c or d to select the phase of subwoofer output. Press c to select reverse phase. Press d to select normal phase.

Adjusting subwoofer settings

When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer.

1 Press AUDIO and NEXT and then press SW2 to select the subwoofer setting mode. 2 Press c or d to select cut-off frequency. Each press of c or d selects cut-off frequencies in the following order: 506380100125 (Hz) Only frequencies lower than those in the selected range are output from the subwoofer.

English

7 Press BAND to cancel the network adjustment mode.

Using subwoofer output

This unit is equipped with a subwoofer output which can be switched on or off. When a subwoofer is connected to this unit, turn the subwoofer output on. The subwoofer output phase can be switched between normal and reverse.

3 Press a or b to adjust the output level of the subwoofer. Each press of a or b increases or decreases the level of the subwoofer. +6  24 is displayed as the level is increased or decreased.

En

49