ZANUSSI FA489
Manual de Usuario

Hydraulic connection
There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3�4� gas for the water supply, a sink, a wash basin or a drainage system in the wall. Previously check if: � it is not a hot water tap. � the running water is clean. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Have the permanent drainage system in the wall checked by a plumber.
P0021

C) Now tighten the nut anew to avoid leaks. (Open the tap and asure that it does not leak and close it again.) D) Place the discharging hose in a washbasin or sink with the aid of the bent piece delivered separately. The bent piece has to be entered into the tube�s mouth in order to assure the support. Aforesaid piece allows the hose to be fixed to the wall by means of an opening on the upper part and that way the hose does not move and its falling is avoided.

A) Place the enclosed rubber joint, delivered in a plastic bag together
A
P0022

with the appliance (A) Fig.6), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not

AL013

to damage the screwdrive and fix the nut well on to the end in order to avoid leaking.

15

ENGLISH

B) If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance.