INSTALLATION
Unpacking
All transit bolts and packing must be removed before using the machine. You are advised to keep all packing for re-use in case you move house and the machine has to be transported again. Proceed as follows: Using a spanner remove the screw on the right at the rear of the machine. Carefully lay the machine on its back making sure that the hoses are not squashed. Place one of the polystyrene angle packings between the machine P0255 and bottom.
Positioning
Position the machine on a firm level surface. The machine must not touch the wall or other furniture. It is assumed that the tap, drainage point and socket are within easy reach of the machine hoses and power supply cable. If not, you are advised to call your fitter in order to move the tap and/or drainage point and/or socket.
P0023
2 1
Water inlet
Connect the water inlet hose to a tap with a 3/4" gas thread spout. The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the inlet hose which could develop due to natural ageing of the hose. This A fault is shown by a red P0271 sector in the window «A». Should this occur, turn the water tap off and refer to your Service Agent to replace the hose. The other end of the inlet hose connected to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten. The inlet hose must not be extended. If it is too P0021 short and you do not wish to move the tap, replace it completely with a longer high pressure hose specifically designed to solve problems of this type.
P0234
P0233
Remove the polystyrene block from underneath the machine. Release the two polythene bags by removing the adhesive strip. Carefully remove the right polythene bag (1) by pulling it towards the centre of the machine. Repeat the operation for the left polythene bag (2).
P0256
P0020
Set the machine upright and unscrew the two remaining rear screws. Slide out the 3 plastic spacers and plug the 3 holes with the 3 plastic plugs which you can find on the back of the machine.
