After using the camera Press the POWER switch on the remote commander. The camera is then in standby status.
2
PRESET
HOME
T
ZOOM
W
HOME
POWER
POWER
T
ZOOM
1 2 3
AUTO
FAR
FOCUS
RESET MANUAL NEAR
The effective area of the remote commander Use the remote commander within the area illustrated below and aim at the receptor of the camera with the remote commander to remote control the camera.
Receptor
BACK LIGHT
POSITION
1
Turning on the camera Press the POWER switch at the rear of the camera to turn on the camera. The main power turns on and you can control the camera with the remote commander. When the main power is on, press the POWER switch on the remote commander to turn on the camera or set the camera to standby status.
5m 30° 15° 30° 15°
Do not apply mechanical shock to the camera when the camera is on The camera may not move even if you press the pan/ tilt buttons. In this case, press the POWER switch on the remote commander or the POWER switch at the rear of the camera to turn off the camera and press the switch again to turn it on.
Lighting up
When the camera is not in use for an extended period of time Press the POWER switch at the rear of the camera to turn off the camera. The main power turns off. In this setting, the remote control cannot operate the camera.
2
Adjusting the direction of the camera Press the pan/tilt buttons to adjust the direction of the camera. Press the pan/tilt button of the desired direction as you check the picture on the screen.
HOME button The camera turns to the front.
PRESET
POWER
HOME
T
ZOOM
W
1 2 3
AUTO
FAR
Pan/tilt buttons
RESET POSITION
FOCUS
MANUAL NEAR
BACK LIGHT
Note
When you press the POWER switch at the rear of the camera to turn off the camera, the preset memory is erased.
