Before you plug it in
Before using your freezer, you are personally responsible for making sure that it... l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l l
is not near an oven,
sourc i!.
radiator
or other
heat
l l
is pro:>erly
maintained.
l
is connected only to the right kind of outlet, with the right electrical supply and grounding. (Referto your�Electrical Requirements and Grounding Instructions.�) is used only for jobs expected of home freezers.
is in c dry sheltered place. * is use j in an area where the room temperature v. ill not exceed 110 F (43.3 C]. l is not un where there are explosive fumes. l is not Jsed by children or others who may not unde stand how it should be used. l is not loaded with food before it has time to get p operly cold.
Install
Properly...
level
IFreezer.. .
&
3 inches above
so that door will stay open at any position. I, Starti rg with door hinge side, turn left to raise corn �r. 2. Turn I ght to lower corner. 3. Chec k with level. 4. After �reezer is loaded with f )od. recheck with level
1 inch in back1
3EEIl II
Clean It...
Raise
lower
IC
1. Check the strength of the floor. It should hold the weight of fully loaded freezer. 2. Pick a safe place, Indoors, away from inflammables such as gasoline. 3. Allow at least 3 inches (7.5 cm) arr space on top of freezer; 1 inch (2.5 cm) at back between condenser and wall and �2 inch (1.25 cm] at each side. 4. The four bolts that held your freezer in the shipping crate are designed to be leveling legs Screw them far enough into the bolt holes in the four corners of the bottom of the freezer so the freezer stands about 1 inch (2.5 cm] off the floor.
Clear your freezer before ing instnictions on page 4.
using it. See clean-
Plug It In...
J-prong grounding
Freezer power c Recommended Grounding Method
Remove
Sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer. Remove any left over glue with rubbing alcohol.
I
Note: tened
DO NOT REMOVE the Tech Sheet fasunderneath cabinet.
I
A 120 Volt, 60 Hz., AC only, 15 ampere fused electric11 supply is required. It is recommended that a st?parate circuit serving only this appliance bt? provided. The receptacle should not be controlled by a wall switch or pull chain. Do no1 use an extension cord. See il\dividual electrical requirements and groundi �rg instruction sheet in your literature packag?