Rinse aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by turning the lid (A) anticlockwise. 2. Add the rinse aid until the container is completely full. The indicator (B) will be completely dark. 3. Top up the rinse aid when the rinse aid indicator light on the control panel illuminates.
SO544
4. Press the "Normal 65°" push button again, the "end of programme" indicator light turns off, this means that the rinse aid indicator light has been deactivated. 5. To memorise the operation, switch off the dishwasher by pressing the On/Off push button. To reactivate the rinse aid indicator light follow the same process until the "end of programme" indicator light starts to flash.
Adjusting the dose
BR01 BR03
If rinse aid refilling is necessary, the rinse aid indicator light will illuminate only in setting mode and at the end of the washing programme. During the run of the programme it will remain off. Ensure that the lid is closed after every refill. Do not put liquid detergent in the rinse aid compartment. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. It is possible to deactivate the rinse aid indicator light (see the following instructions). By default the rinse aid indicator light is active.
According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes.
To deactivate the rinse aid indicator light be sure that the dishwasher is off and then proceed as follows:
1. Press "Intensive 70°" and "Normal 65°" programme push buttons simultaneously. 2. While keeping the programme push buttons "Intensive 70°" and "Normal 65°" pressed switch on the dishwasher by pressing the On/Off push button. The On/Off indicator light comes on. At the same time, the indicator lights of the "Intensive 70°" and "Normal 65°" push buttons start flashing.
BR02
SO542
3. Press the "Normal 65°" push button, the correspondent indicator light keeps flashing while the indicator light of the "Intensive 70°" push button turns off. At the same time the indicator light "end of programme" starts to flash.