Building-in
Before carrying out any work, remove the plug from the power socket.
Building in the appliance under a worktop
The dimensions of the recessed installation area must correspond with those indicated in the figure.
Grid preparation
Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure).
600
A B
55 min0 .
600
DO013
Installation kit
DO002/2
1xB
2xC
Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). To position the grid on the appliance proceed as follows: Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click.
1xA
12 2 2 1 1 2
1
a 1. Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. - To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet. - Position the two brackets as shown in the figure and replace the two securing screws.
