Installation
Uppställning av dörrarna (om så krävs)
� Stäng dörren och kontrollera att panelen sitter på rätt höjd, använd de inställningsskruvar som sitter ovanför plattan och ovanförgångjärnet vid behov. � � During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the instructions. Attention: keep ventilation openings clear of obstruction. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions. � Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable.
�
Använd samma inställningsskruvar för den vertikala uppriktningen av panelerna.
�
Disposal of old Appliances
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
� � Kontrollera den horisontala uppriktningen av panelerna och korrigera eventuellt deras position genom att låta dem löpa i skårorna.
IMPORTANT SAFETY INFORMATION
Building the appliance in
� �ppna dörren. Reglera jämnheten mellan panelerna med hjälp av inställningshylsorna och den nedre hållaren. � � Fit the appliance into the recess. Rotate the bracket of 180° in order to obtain the right position ( 2). The position (1) is on the delivery. Fix it to a solid wall with the appropriate bracket.
1 2
�
�
När dörrarna har uppriktats skall man sätta i en fästskruv inuti hylsorna (övre och nedre gångjärn) och i den nedre hållaren. Dra åt skruvarna inuti hålen.
