Installation
Positioning
� Place the refrigerator away from direct sunlight and heat sources. � Maintain recommended ventilation - see Fig. 1. If the temperature are higher than these both above mentioned, the functions of appliance coudl result reduced.
Cleaning the interior
� Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet. � Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brand-new product arid then dry thoroughly. � Do not use detergents or abrasive powders as these will damage the finish. � Remove security used for transportation.
Fig. 1
� Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises, Fig. 2.
Electrical connection
m Before plugging the appliance make sure that the voltage and frequency shown on the «Technical Features» correspond to your home supply. It is essential that the appliance be efficiently earthed. m For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED».
Fig. 2
� In the documentation bag you will find two spacers that must be mounted as shown in the figure in the back of your appliance. Please loosen the screw under its head and then unloosen again.
Starting � up
� Plug the appliance into the mains. � Make sure the inner light turns on when opening the door. � Turn to intermediate position the knobs of the «temperature regulator» «A» (See Control And Use paragraph).
D
� This is a built in design to be aligned with other furniture � The appliance must be located in places of maximum temperature as follows: SN N ST T +10 +16 +18 +18 hasta hasta hasta hasta +32ºC +32ºC +38ºC +43ºC