CLEARAUDIO EMOTION&SATISFY
Manual de Usuario

Emotion & Satisfy
Bedienungsanleitung/USER MANUAL

3. Installation and set up
The Emotion -turntable comes in several pre mounted parts, as described under chapter 2 (Scope of supply). The set up and installation is done quickly and very easy. Please use the white gloves during this procedure, to avoid scratches. You should consider a safe and clean working area for the installation, in spite, as near as possible to the final position of the Emotion-turntable. First take out the motor and tonearm of the packing. Now you should take out the first packing layer. After that you can take out the Emotion-turntable body from the next packing layer. Place the turntable body on a on a clean underlay so that the bearing hole is facing upside. In the accessory bag (placed in the top packing layer) you will find 3 acrylic spikes, 3 stainless steel threaded bolts and 3 rubber-o-rings. Screw the 3 bolts about 10 millimetre inwards into the Acrylic spikes. Now place the 3 rubber-o-rings over the bolds and slide them to the bottom as well. Screw the 3 spikes into the pre drilled holes of the turntable body, while tightening them gently. Then take the turntable body and place it on the area where the final position of your Emotion-turntable will be. Now take the motor-pulley out of the accessory bag and shift the motor pulley as far as on the motors shaft until you have a distance of approximately 1 mm between the upper edge of the motor and the lower edge of the pulley. Now screw the three screws in the pulley one after the other with the precision screw driver. Lift the turntable chassis and slide it over the motor unit through the motor-position hole in the turntable body so that the rubber-o- ring around the housing of the motor is fixing the final position. Please pay attention, that the switch of the motor is outside on the left side of the record player body. Tip: You have also the possibility to take off the rubber-o-ring of the motor�s housing to centre the motor in the motor-position hole without any contact to the turntable chassis ! This way you can use your Emotion-turntable perfectly decoupled from the motor. Now you can connect the power cord to your power outlet. On the bottom packing layer you will find the turntable platter. Please take the platter with both hands and place it on the bearing upper part. Through a lightly up and down movement the platter will slip onto the bearing upper part. Make sure with a gently pressure that the platter is applying on the complete surface of the bearing. Place the clearaudio level gauge on the platter and bring the turntable in level by turning the corresponding spikes in the right direction.
Seite/Page 19  clearaudio electronic GmbH 2005