Adjustment Method for Weight Sensor
When the main PCB or weight sensor is changed, please carry the following �Zero� adjustment out for the weight sensor. Procedure 1. 2. 3. 4. 5. Plug in power cord (note: please do not touch the �Clear� key) Open the door Place metal turntable Close the door Touch �More/Less� key two times (No beep sound when key is touched) Touch �Weigh Dish� key two times Touch �START� key After 4 sec. display shows 1230 Open the door Place the glass turntable Close the door Touch �START� After 4 sec. display �1230� stops the flashing Display Demonstration words �WELCOME SANYO....�
6. 7. 8. 9. 10. 11. 12. 13.
Flashing �0000� Flashing �1230�
�1230�
Note: When the display show the error mark �E-� during setting,please try again from the beginning. In this case, please check if the wiring between weight sensor and main PCB is correctly connected.