Figure 4-5 DVD fixation screws. 4.1.4 DVD Eject Switch � To access the DVD eject switch, unscrew the two fixation screws and pull the switch out of the cabinet. Remove the switch cable if necessary. The switch panel can now be removed. To reassemble the switch, make sure that the cable is fixed before mounting.
Figure 4-7 Cable routing 2.
�
4.1.5
Attention Point � The routing of some cables is very critical. So therefore, take care that the cables are routed as shown in pictures hereunder. Not routing the cables in this way can cause problems like picture disturbance and EMC problems. � Routing of the cable between LSP connector 1936 and DVD Interface connector 0240 (blue 11-pins cable): guide the cable as close as possible to the SSB shielding en than between the cable relief of the scavem-assy (Auto-scavem board itself is not present in EM5E-DVD), and from there to the DVD-interface. (See figure �Cable routing 1�) � Routing of speaker cable and top control cable: make sure this cables are routed between the DVD lock plate and the DVD board. Also make sure to guide them underneath the two flat foil cables. (See Figure �Cable routing 2.�)
