WHIRLPOOL EH18VSXLN2
Manual de Usuario

Before you

plug

it in
l l l

Before using your freezer, you are personally responsible for making sure that it...
l

is properly

maintained.

l

is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use. is connected only to the right kind of outlet, with the right electric supply and grounding (see below) is used freezers. only for jobs expected radiator of home or other heat

is in a dry sheltered area. is used in an area where the room temperature will not exceed 110 F (43.3 C]. is not run where there are explosive fumes. is not used by children or others who may not understand how it should be used. is not loaded with food before it has time to get properly cold.

l l

l

l

l

is not near

an oven,

Install

Properly.

..

Level Chest Freezer.. .
from end to end and front to back WIII seal properly Check with level d so that the Ild

Install the Battery...
You will find the freezer key and a 9-volt alkaline battery packed inside the freezer. Install the battery by following instructions on page 4. The Temperature Alarm will sound a continuous tone if the Temperature Alarm Switch is in the ON or TEST position. Move the switch to OFF until the freezer is cold. Then move it to ON.

1. Check the strength of the floor. It should hold weight of fully loaded freezer. 2. Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way. 3. It should not be necessary to remove the lid during installation, If, for any reason, the hinges need adjustment, see your authorized WHIRLPOOL dealer. 4. Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.

Install the Defrost

Drain Cover...

Packed inside the freezer is the Defrost Drain Cover and a hose adapter. Keep the hose adapter in a handy place to use when defrosting the freezer. Install the Defrost Drain Cover over the opening in the lower left, front corner of your freezer.

Plug It In...

Remove

Sales label...

Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol. Note: DO NOT REMOVE the Care and Service label on the inside lid. This permanent label provides immediate information should it be needed. Do not remove Tech Sheet permanently attached to back of cabinet.

Recommended

Grounding

Method

Clean

It...
using it. See clean-

Clean your freezer before ing instructions on page 4. 2

A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. The receptacle should not be controlled by a wall switch or pull chain. Attach retaining clip over power cord plug from the literature package inside your freezer Do not use an extenslon cord.