WHIRLPOOL EH150CXKW2
Manual de Usuario

Before you pluc1 it in
Before using your freezer, you are personally responsible for making sure that it... l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use. l is connected only to the right kind of outlet, with the right electric supply and grounding (see page 3).
l

is used freezers.

only

for jobs

expected radiator

of home heat

. is properly maintained. . is in a dry sheltered area. . is used in an area where the room temperature will not exceed 110 F, (43 3 C). . is not run where there are explosive fumes. . is not used by children or others who may not understand how it should be used. . is not loaded with food before it has time to get properly cold.

l

is not near an oven, source.

or other

Install

Properly..

.

level

Chest Freezer.. .
so that the Ird

from end to end and front to back will seal properly.
Check with level

Allow

room to open l-1 I

lid

1

r--l,

2 inches at back

IW

I

1

I

II

I
riinches Jinches1li,

1111

Remove

Sales label...

Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol. Note: DO NOT REMOVE the Care and Ser-

f

1. Check weight

the strength of the floor. It should of fully loaded freezer.

hold

vice label on the inside lid. This permanent label provides immediate information should it be needed. Do not remove Tech Sheet permanently attached to inside of service panel.

2. Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way. 3. It should not be necessary to remove the lid during installation. If, for any reason, the hinges need adjustment, see your authorized WHIRLPOOL dealer. 4. Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.

Clean

It...
using it See clean-

Clean your freezer before ing instructions on page 4.

Defrost
Installing

Drain Cover.. .
Defrost Drain Cover: from literature package. on page one for placement

1. Remove cover 2. Check drawing 3. Install cover.

2