Fitting the Cooker Hood to the Wall
1. Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided. Once the brackets are secured, lift the hood squarely to the wall slightly higher than the brackets. Lower the cooker hood until it is located onto the two brackets. Ensure that the cooker hood is correctly located before letting go. 3. Access to the two wall levelling screws is from above the hood. These are located in the two extension arms at either side of the hood. Level the hood using the screws located in each extension arm. By loosening the screws at the front of each extension arm the hood can be aligned with the front of the adjoining wall cabinets. The hood should be secured on each side to the adjoining wall cabinets using the 4 x 15mm (1/2 ins) security screws provided. Adjust the lower spacer panel at the rear of the hood to close the gap to the wall.
2.
4.
5.
6.
Decor Panel
The dimensions of the door panel should be 59.6cm (23 1/2 ins) wide by 35cm (13 3/4 ins) in height.
Fitting a Decor Panel to the Hood Visor
1. Remove the complete visor assembly by pulling open into the operating position, simultaneously press down on the release catch located behind the visor on the left hand side of the casing. Using the paper template provided, mark the screw hole positions on the reverse side of the decor panel. Ensure that the paper template is aligned with the top edge of the decor panel.
