Installation
Mounting accessories included
4 screws 5 x 45 mm 4 wall plugs (brick fixing) � 8 mm 4 screws 4,2 x 35 mm 1 flange � 125 mm 1 allen spanner (for TORX screws) 1 screw 2.9 x 13
1 2
3
Wall unit mounting
� Make the holes on the bottom of the cupboard (2), using the drilling template (1). Make a hole for the exhaust pipe (4) if the hood is to be used in the extraction version (3). � From inside the cupboard, insert the 4 supplied screws (5) and tighten them in the appropriate holes on the appliance.
5
5 5 4
5
Wall mounting
� Mark a centre line on the wall (1). Fit the template onto the wall (2). � Fix the drilling template to the wall. � Make 3 � 8mm holes in the wall (3), 2 at upper points, 1 as desired at lower points. � Insert the three � 8mm expansion plugs into the wall (4) (brick fixing only).. � Insert 2 5x45 screws (5) but do not tighten them completely, hang the hood (6). � Adjust the unit so that it is positioned at a right angle to the wall by turning the two screws on lower side (7). � Tighten the 2 upper screws (8). � From inside the hood, insert the third 5x45 screw into the lower hole (9) and tighten (10).
