Charcoal filter
� The charcoal filter should only be used if you want to use the hood in its filtering function. � To do this you will need an original AEG charcoal filter (see special accessories). � Replacing the charcoal filter The charcoal filter must normally be replaced at least once every year. This filter cannot be washed or regenerated. To guarantee proper absorption of odours the working volume of the charcoal must be proportionate to the hood air flow. In this case the high quality of the charcoal will ensure efficient odour removal for approximately one year, assuming that the hood is used normally. For this reason you should always use original AEG filters only, making sure they are replaced when necessary. � Mounting 1. Pull out the vapour catcher (Fig. 1 - A). 2. Remove first the rear then the front grease filters. 3. Insert the charcoal filter into the lugs of the holding frame above using the 2 red clips to retain it below, press the red clips inwards, and insert the charcoal filter in the holding frame. Fig. 4. � Dismounting: 1. Press both red lugs upwards (towards the inside of the housing) and remove the charcoal filter downwards. 2. Clean the internal housing only with warm washing-up liquid� suds (never use any abrasive cleaners, brushes, or scouring agents). � Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. � The charcoal filter can be ordered from the AEG technical assistance service.
CLOSED
CLOSED
Fig. 4
Changing the light bulb(s)
� Disconnect the unit from the mains power supply. � Pull out the drawer. � Open the lamp cover support. � Replace the old light bulb with a new light bulb of the same kind. � Replace the lamp cover support. � If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service.
