Power Level Calibration
Before starting Power Level Calibration, the Power Ramp Editor should be enabled. The mobile should be connected to GSM Tester or Power Meter.
1. Select the required Band and PA Level, and click the "Get" button. The default ramping value for the selected band and PA Level will be displayed. 2. Input the Tx ARFCN (EGSM = 45 ch, DCS = 633 ch ), and press Enter key. 3. Check the "Burst Tx" of the RF Mode. The handset will transmit and the power meter will display the default Tx power level.
NOTE: To stop the handset transmitting, click "General off".