PANASONIC DX2000AU
Manual de Usuario

Sending Documents via Telephone Line
Manual Number Dialing
To dial the telephone number manually, follow the steps below. (see Note 1) (see Note 2)

1
Set document(s) face down.

ENTER STATION(S) THEN PRESS START 00%

4

2 3 4

MEMORY

Make sure that the MEMORY lamp is on. If not, press MEMORY to set �On�. Enter a telephone number from the keypad. Ex: 5 5
5551234� TEL. NO.

51234

* STORE * NO.001 PAGES=001 01%
START

The document(s) begin to store into memory with a file number. Then starts dialing the telephone number immediately after storing the first page. (See Note 3) The remaining page(s) continue to store into memory. (see Note 3)

* DIALING * 5551234

NO.002

Note: 1. If you need a special access number to get an outside line, dial it first then press PAUSE to enter a pause (represented by a "-") before dialing the full number. Ex: 9 PAUSE 5551234 2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing, press TONE (represented by a "/"). The dialing mode will be changed from Pulse to Tone after dialing the digit "/". Ex: 9 PAUSE TONE 5551234 3. This feature is called �Quick Memory Transmission�. If you wish to store All the document(s) into memory first before transmitting, change the Fax Parameter No. 082 (QUICK MEMORY XMT) to �Invalid�. (See page 74)

93