Filling with salt
If your water is "level 0" it is already soft and therefore there is no need to use salt. Salt must be used from level 1 upward. Only use salt specifically designed for use in dishwashers. Other types of salt may reduce the efficiency of the softener. Only fill with salt just before starting one of the complete washing programmes (not the Rinse and Hold programme).This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion.
To fill:
� � To fill with salt, unscrew the cap of the salt container. Pour about 1 litre of water inside the container, or until it is full (this is necessary only before filling with salt for the first time). � Then using the funnel provided, pour in the salt until the container is full (approx. 1.5 - 1.8 kg). Do not worry if water over flows from the unit when filling with salt, this is quite normal. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. Screw on the cap tightly.
LE SA LT SA LZ SA L SE
�
SR06
�
The salt container will require topping up periodically. The �Salt refill� indicator light on the control panel will illuminate when the salt has finished, and requires refilling. The salt container has always some water inside which will normally overflow when refilling with salt. The �Salt refill� indicator light can remain illuminated for 2 - 6 hours after salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the dishwasher is not affected.