SHARP DVS1H
Manual de Usuario

DVD SETUP Audio Setting
Choose the appropriate Audio settings for your equipment as it only affect during the playback of DVD discs of the DVD player.

Display Setting
You can change certain aspects of the DVD�s display screens, on-screen messages and the display panel on the front of the DVD player. 1 Press SETUP during playback is stopped. 2 Press K or L to select DISPLAY, then press

NOTE:
� These audio settings are effective only when using a digital connection. Although you may change the settings from the on-screen display, these audio settings do not actually affect the sound when using an analogue connection. 1 Press SETUP during playback is stopped. 2 Press K or L to select AUDIO, then press ENTER. 3 Press K or L to choose the below items and press

ENTER.
3 Press K or L to select the below items, then press

ENTER. TV Aspect: � Press K or L for an item selection, then press

ENTER repeatedly to turn the setting ON or OFF. Dynamic Range Control (DRC):
� The default setting is OFF. � To compress the range of sound volume.

Dolby Digital :
� The default setting is Bitstream. (Bitstream : Output by Dolby Digital) (DPCM : Convert the Dolby Digital to D-PCM) Set to Bitstream when the unit is connected to Dolby Digital Decoder.

ENTER. � Select 4:3 LETTER BOX for a black bars appears on the top and bottom of the screen. � Select 4:3 PAN & SCAN for a full height picture with both sides trimmed. � Select 16:9 WIDE if a wide-screen TV is connected to the DVD player.

Panel Display: � Press K or L to select BRIGHT, DIMMER and AUTO,
then press ENTER. � This adjust the brightness of the display panel with the factory default BRIGHT. � When AUTO is selected, the display dims only during playback.

DTS:
� The default setting is OFF. Set to On when the unit is connected to DTS Decoder. (On: Output by DTS)

Angle Icon:
� Press ENTER repeatedly to turn Angle icon ON or OFF. � The default setting is ON.

MPEG:
� The default setting is OFF. (On : Output by MPEG sound) (OFF: Convert the MPEG to PCM) Set to On when the unit is connected to MPEG Decoder.

Auto Power Off:
� Press ENTER repeatedly to turn Auto Power ON or OFF. � The default setting is ON and it will turn the DVD player to off automatically after 35 minutes of no use. 4 Press SETUP to exit.

DOWN SAMPLING:
� The default setting is AUTO. � Press ENTER, then K or L to select AUTO, 48kHz or 96kHz. Press ENTER again to confirm selection. � Select 96kHz if the disc was recorded in PCM 96kHz, otherwise select 48kHz. 4 Press SETUP to exit.

Black Level Setting
Adjust the Black Level Settings to make the black parts of the picture as bright as you preferred. 1 Press MODE during playback. 2 Press ENTER repeatedly to select ON or OFF. ON: makes the dark parts brighter. OFF: shows the original picture as recorded.

NOTE:
� Black Level Setting is not available if your TV is set to receive the RGB signal (see page 8 for more infomation).

� 18 �

EN