PIONEER DVR-RT301-S
Manual de Usuario

Additional information

09

Video head cleaning
Video head clogging
The video heads are the means by which the DVD/VCR reads the picture from the tape during playback. In the unlikely event that the heads become dirty enough to be clogged, no picture will be played back. This can easily be determined if, during playback of a known good tape, there is good sound, but no picture (picture is extremely snowy). If this is the case, have the DVD/VCR checked by qualified service personnel.

Hints on installation
We want you to enjoy using this unit for years to come, so please bear in mind the following points when choosing a suitable location for it:

Do...
Use in a well-ventilated room. Place on a solid, flat, level surface, such as a table, shelf or stereo rack.

Don't...
Use in a place exposed to high temperatures or humidity, including near radiators and other heatgenerating appliances. Place on a window sill or other place where the recorder will be exposed to direct sunlight. Use in a dusty or damp environment or in a room where it will be exposed to excessive cigarette smoke. Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use. Use near a television or monitor as you may experience interference-especially if the television uses an indoor antenna. Use in a kitchen or other room where the recorder may be exposed to smoke or steam. Use on a thick rug or carpet, or cover with cloththis may prevent proper cooling of the unit. Place on an unstable surface, or one that is not large enough to support all four of the unit's feet.

Normal Note

When head is dirty

� DO NOT ATTEMPT TO CLEAN THE VIDEO HEADS OR SERVICE THE UNIT BY REMOVING THE TOP COVER. � Video heads may eventually wear out and should be replaced when they fail to produce clear pictures. � To help prevent video head clogging, use only good quality VHS tapes. Discard worn out tapes. � We do not recommend using wet-type headcleaning cassettes as they may damage the unit.

Moving the recorder
If you need to move the recorder, first remove the disc and the cassette, if they are loaded, and close the disc tray. Next press STANDBY/ON to switch the power to standby. Lastly, disconnect the power cord.

Resetting the recorder
If you need to, you can reset the recorder to all its factory settings. 1 Make sure that the recorder is on and remove the disc. 2 Press and hold STOP and press w STANDBY/ ON. The recorder turns off with all settings reset.

89
En