2 After making the settings, press ENTER. The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited. � If you haven�t set up the guide channels (or at least the guide channel for the PlusCode programming number that you entered), the recorder will prompt you to enter the channel number that the TV program is showing on.
1 Press �VIDEO Plus+�. The front panel display shows the current recording mode and prompts you to enter the PlusCode programming number.
P L US CODE
2 Use the number buttons to enter the PlusCode programming number.
2 9 32 4
� To clear the last digit entered, press CLEAR. � Use the PREV / NEXT button to switch VPS/ PDC on/off. With VPS/PDC on, the front panel VPS/ PDC indicator lights. (Note that a maximum of 8 timer recordings can be set with VPS/PDC on.) 3 Press ENTER. The display shows the timer settings: Date Start time End time Recording channel. � If CODE ERROR appears in the display, check that the PlusCode programming number is correct and that the guide channel is set (see Set VIDEO Plus+ CH on page 81), then set the timer recording again. � If CAN�T SET appears in the display, it means that although you entered a valid PlusCode programming number, the program has already finished.
Tip � You can check the timer program settings by pressing TIMER REC to display the timer recording screen.
VIDEO Plus+ programming with the power off
You can enter a PlusCode programming number when the recorder is in standby.
VIDEO Plus+
CLEAR
Extending a timer recording in progress
You can extend a timer recording beyond the programmed end time in two different ways. This can be useful if a broadcast program overruns, for example.
CLEAR
ENTER
ENTER
PREV
NEXT
HOME MENU
ì
Important � You can�t use this feature until you have set up the guide channels. See Set VIDEO Plus+ CH on page 81. � You can�t change the recording mode. � You can�t program daily or weekly timer recordings.