Getting Started
Setting up Progressive Scan feature (for Progressive Scan TV only) The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality. IMPORTANT! Before enabling the progressive scan feature, you must ensure: 1) Your TV can accept progressive signals, a progressive scan TV is required. 2) You have connected the DVD player to your TV using Y Pb Pr (see page 9.)
ACTIVATING PROGRESSIVE SCAN: 1. ENSURE YOUR TV HAS PROGRESSIVE SCAN. 2. CONNECT USING YPBPR (GBR) VIDEO CABLE. 3. IF THERE IS A DISTORTED PICTURE, WAIT 15 SECONDS FOR AUTO RECOVERY.
OK
Cancel
8 Press 1 to highlight
OK
in the menu
and press OK to confirm. There will be a distorted picture on your TV at this state until you turn on the progressive scan mode on your TV.
9 Turn on your TV progressive scan mode
(refer to your TV user manual.) � The below menu appears on the TV.
1 Turn on your TV. 2 Turn off your TV progressive scan mode
or turn on interlaced mode (refer to your TV user manual.)
CONFIRM AGAIN TO USE PROGRESSIVE SCAN. IF THE PICTURE IS GOOD, PRESS OK BUTTON ON REMOTE.
OK Cancel
3 Press POWER (B) on the remote
control to turn on the DVD player.
0 Press 1 to highlight
OK
in the menu
4 Select the correct Video Input channel.
on the TV.
(See page 14). � The DVD background screen appears
and press OK to confirm. � The set up is complete now and you can start enjoy the high quality picture. To deactivate Progressive manually: G Wait for 15 seconds for auto recovery. OR
5 Press SETUP. 6 Press 2 to select {VIDEO SETUP PAGE}.
General Audio Video Preference
1 Press OPEN/CLOSE on the DVD player
to open the disc tray.
- - Video Setup Page - TY Type TV Display Progressive Sharpness Brightness Contrast Color On Off
2 Press numeric keypad �1� on the
remote control for few seconds. � The DVD background screen appears on the TV. Helpful Hint: � There are some progressive scan TV and High-Definition TV sets that are not fully compatible with this DVD system, resulting in the unnatural picture when playing back a DVD VIDEO disc in the progressive scan mode. In such a case, turn off the progressive scan feature on both the DVD player and your TV set.
7 Select {PROGRESSIVE} to {ON}, then OK
to confirm. � The instruction menu appears on the TV.
TIPS:
The underlined option is the factory default setting. Press 1 to go back to the previous menu item. Press SETUP to exit the menu item.
