|
Usuarios conectados
Actualmente hay 5715 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Preparation
Replacing battery (lithium CR2025) into the remote control 1 2
Pull out the lithium battery compartment. Replace a new battery and fully insert the battery compartment back to the original position.
Switching On 1
Be sure that the DVD player has been correctly connected to the TV and audio equipment. Switch on the TV and DVD player. Set the TV to the correct Video In channel. (eg. EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc. Please refer to your TV owner's manual for details.) § The player display lights and the default screen appears on the TV. If you are using an external equipment (eg. audio system or receiver), turn it on and select the appropriate input source for the DVD player output. Refer to the equipment owner�s manual for detail.
DC - - - 3V CR2025 LITHIUM BATTERY
2 3
C R2025
+
3V
CR2025
+
CAUTION! � Insert the plastic protective sheet if they are not to be used for a long time. � Batteries contain chemical substances, so they should be disposed off properly and kept away from children.
4
Smart Power On/Off
Using the Remote Control
q Pull out the plastic protective sheet which is used to keep the lithium battery fresh. q Direct the remote control at the remote sensor of the DVD player. q Do not drop or give the remote control a shock. q Do not leave the remote control in extremely hot or humid places. q Do not spill water or put anything wet on the remote control. When in STOP or NO DISC mode, the DVD player will switch to standby mode after 15 minutes without any operations for saving energy. It is easily reactivated by pressing the POWER or PLAY key on the remote control or the PLAY/ PAUSE button on the front panel.
LITHIUM BATTERY
DC - - - 3V CR2025
1 2
Connecting the Power Supply
Plug the female end of the power cable supplied into the power connector on the rear of the player. Plug the male end of the cord into an AC outlet. Note: When the DVD player is switched to Standby mode, it is still consuming some power. If you wish to disconnect your player completely from the mains, withdraw the plug from the AC Outlet.
11
English
|
|
|
> |
|