Timer Recording
About timer recording
Use the timer recording to automatically start and stop a recording at a later date/time. The recorder will tune to the right programme channel and begin recording at the specified time. With this recorder, you can schedule up to 8 recordings at a time. During timer recording, changing the recorder�s channel is not possible. There are two ways to programme a timer recording � Using the ShowView / VIDEO Plus+ system. � Using manual timer schedule.
Timer recording (SHOWVIEW® / VIDEO Plus+ System)
This is a simple timer programming system. To use, enter the ShowView programming number / VIDEO Plus+ PlusCode number associated with your television programme. You can find this number in your TV listings magazine. All the information needed by this recorder for programming is contained in the programming number.
A Turn on the TV to the correct viewing
channel for the recorder (e.g. �EXT�, �0�, �AV�).
B Press SHOWVIEW (or VIDEO
Plus+) on the remote control. The SHOWVIEW / VIDEO Plus+ System menu appears.
ShowView System
Enter the ShowView programming number for the show you wish to record.
CLEAR OK
TIMER
SHOWVIEW
CONFIRM
CANCEL
OK
C Use the numeric keypad 0-9 to enter
About �VPS/PDC� �VPS� (Video Programming System) or �PDC� (Programme Delivery Control) is used to control the start and duration of TV channel recordings. If a TV programme starts earlier or ends later than was scheduled, the recorder will then turn on and off at the correct time. VPS/PDC is intended to record the entire programme. To set a timer that is longer/ shorter than the VPS/PDC broadcast time, you must switch off the VPS/PDC.
TIPS: Ensure that there is sufficient space available on the recordable DVD or VHS tape before recording. You have to finalise the DVD±R before it can be playback on other players.
the ShowView / PlusCode programming number for the show you wish to record. (e.g. : 5-312-4 or 5,312 4, key in �53124�). To clear the programming number, press CLEAR on the remote control. To cancel the programme, move to CANCEL in the menu and press OK.