|
No hay comentarios de productos.
Before Using the DV-CP802
Installing the Remote�s Batteries Using the Remote Controller
To use the remote controller, point it at the DV-CP802�s remote control sensor, as shown below.
Remote control sensor DV-CP802
STANDBY/ON
STANDBY
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in accordance with the polarity diagram inside the battery compartment.
30�
30�
Ap
ox pr
. 16
ft
. (5
m
)
3
Close the battery compartment.
Notes: � The remote controller may not work reliably if the DV-CP802 is subjected to bright light, such as direct sunlight or inverter-type �uorescent lights. Keep this � in mind when installing the DV-CP802. If another remote controller of the same type is used in the same room, or the DV-CP802 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. Don�t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. The remote controller may not work reliably if the DV-CP802 is installed in a rack behind colored glass doors. Keep this in mind when installing the DV-CP802. The remote controller will not work if there�s an obstacle between it and the DV-CP802�s remote control sensor.
� Notes: � The supplied batteries should last for about six months, although this will vary with usage. � If the remote controller doesn�t work reliably, try replacing both batteries. � Don�t mix new and old batteries, or different types of batteries. � If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. � Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion. � �
16
|
