PIONEER DV-667A-S/BKXJ
Manual de Servicio

5

6

7

8

7.1.10 DISASSEMBLY
Note: For performing the diagnosis shown below, the following jig cables for service are required: � GGD1330 �2
A

Diagnosis of the PCBs
Procedures ; JCKB Assy : ¥ � ø � � DVDM Assy : ¥ � ø � [

1 Bonnet and Tray Panel

1 2 3 4 5 6

Remove the Bonnet by removing the five screws. Press the STANDBY/ON button to turn on the power. Press the 0 button to open the tray. Remove the tray panel. Press the 0 button to close the tray. Press the power. STANDBY/ON button to turn off the

26

B

4 3 5
Tray Panel Tray

35
C

How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the loading mecha. assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.

D

Screwdriver (small) Projection

Slit Drive Gear Loading Mecha.Assy
E

Tray open

Screwdriver (small)
F

DV-667A-K
5 6 7 8

67