PIONEER DV-47A/KUXJ/CA
Manual de Servicio

DV-47A, DV-S733A, DV-747A

6.5 MECHANISM ADJUSTMENT
1 Tangential and Radial Height Coarse Adjustment START
� Remove the servo mechanism. � Remove a Spacer for height adjustment attached to the back side (shaded area) of the Servo Mechanism (Float Base) with nippers. Cautions: Because there is not a Spacer for height adjustment in adjustment after the second time, will keep it at need. (This parts is Traverse mechanism exclusive use of a model for 2001 years) 7.3mm
Servo Mechanism

Float Base

Put a spacer between a Tangential (or Radial) adjustment screw and Mechanism Base and turn each screw to adjust the height. (Refer to "6.1 ADJUSTMENT ITEMS AND LOCATION".)
Spacer for Height adjustment

Note: Turn the Short switch to Short side when removing the Pickup Flexible Cable. (Refer to "7.1.7 DISASSEBLY".)

Turn a flat side into bottom

73