1 Tangential and Radial Height Coarse Adjustment START
� Remove the pickup Assy from the Traverse Mecha. Assy. � Remove the joint and the joint spring of the pickup Assy.
Pickup Assy
Note: Before removing the flexible cable for the pickup, soldering of the pickup circuit is necessary. For details, see "7.1.10 DISASSEMBLY".
Joint Joint Spring
B
� Pass through the guide shaft to a new pickup Assy-S. � Attach it to the Traverse Mecha. Assy.
Pickup Assy-S
C
Guide Shaft
D
� Put the joint between the Tangential (or Radial) adjustment screw and the Mechanism Base and turn each screw to adjust the height. (Refer to "6.1 ADJUSTMENT ITEMS AND LOCATION".)
Joint
7.5mm Mechanism Base
E
� Attach the Traverse Mecha. Assy to the Loader Assy. � Turn it over and attach the joint and the joint spring. � Arrange the flexible cables. (Refer to "7.1.10 DISASSEMBLY".)
