WHIRLPOOL DU9200XT4
Manual de Usuario

HEAT DRY
The AIR DRY signal light will be OFF when HEAT DRY is selected. Heat Dry means the air in the dishwasher is heated during of any cycle - except RINSE

HI-TEMP
When HI-TEMP is selected, = - �. the water for the main wash and final rinse is heated to 145°F (63°C). m While the water is heating, the WATER HEATING signal light will be ON. POTS & PANS has the HI-TEMP option preset. HITEMP cannot be selected with RINSE & HOLD. NOTE: The WATER HEATING signal light flash at the end of the cycle if the water not heat to 145°F (63°C). (See page 17). will did

the �dry� portion & HOLD.

AIR DRY
The AIR DRY signal light will be ON when AIR DRY is selected. The AIR DRY Option helps save enerqv, but the dishes take longer to dry (overnight)and some water spotting may result. Some items (such as plastics] may need towel drying. For best results, use a liquid rinse aid such as Jet-Dry� in the rinse aid dispenser.

DELAY Pad
. -

B
mm.

1

�The DELAY Pad allows you to delay the start of

3. Pressing the DELAY Pad repeatedly will select (in order] no delay, then 2 hours, etc. If no delay is selected, all delay signal lights will be
Off.

ing the dishwasher. run the dishwasher electrical use. 1. Press the DELAY pad once to display the last cycle and options selection. 2. Quickly press the pad again to select a 2 hour delay. The 2 HOURS signal light will come on.

a cycle for 2 hours after loadFor example, use DELAY to during off-peak hours of

4. After 2 hours, the signal light will turn off and the dishwasher will start. You may press START at any time during the l delay if you want the dishwasher .__._. to start .- - immediately. l Press the CANCEL pad to cancel the delay and clear the delay signal light. l You may add items to the load at any time during the delay. Close the door firmly to latch it.

CANCEL Pad
The CANCEL pad allows you to cancel a cycle, to clear the signal lights or to make a new selection. If the dishwasher is washing, itwill go into a 2 minute drain automatically before shutting off. Pressing CANCEL again stops the drain. If the dishwasher had not been started or is not washing, it will clear the display. Pressing CANCEL again will start a 2 minute drain, if needed.

10