WHIRLPOOL DU8900XT3
Manual de Usuario

To add a dish after starting
1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LOW ENERGY WASH. 2. Lift up on the door latch to unlatch the door and to stop the cycle. Don�t open the door until the spray arms stop spinning. 3. Open the door and add the dish.

4. Close the door, Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle. 5. Latch the door. The dishwasher will Start from where it stopped.

The CLEAN Signal Light
The CLEAN Signal Light will come washing cycle is complete. on when a To turn light off, turn the Control Knob clockwise slightly until the light goes off.

Energy saving tips
You can help save energy if you:

1. Wash full loads. Running a half-filled dishwasher uses the same amount of electricity and hot water as a fully loaded machine.

2 Use the LOW ENERGY WASH Cycle whenever possible. It uses less hot water and energy than otherwash cycles.

3. Air dry dishes drying cycle. [overnight).

when You don�t need a rapid Allow longer drying times

4. load correctly for best washing results. Incorrect loading may cause poor washing and the need to rewash all or part of the load. 5. Don�t pre-rinse normally soiled dishes. Select the correct cycle for the load and use the recommended amount of detergent for good washing results without hand rinsing. 6. Use your dlshwasher dunng off-peak hours Local utilities recommend this to avoid heavy usage of energy at certain times of

dav
7. Kitchen cleanup can be done quickly and efficiently through the use of Your dishwasher. Most appliance parts that can fit in the dishwasher can be cleaned by it. Burned-on soil, however, should be cleaned by hand.