|
Usuarios conectados
Actualmente hay 5889 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Advanced Setup
Decoder Setup
Here are surround-related settings for PCM, Dolby Digital, multichannel, and other input signal formats.
3-1. Analog/PCM
These settings apply to PCM input signals from CD players and so on, and analog signals from cassette players, turntables, and so on. â� a. Input Channel (Mono) This setting determines which channel is output when the Mono listening mode is used with a stereo source. L+R: Both the left and right channels are output (default). Left: Only the left channel is output. Right: Only the right channel is output. â� b. Surround Mode This setting determines the surround mode for analog and PCM input signals. This setting is unavailable if no center and surround speakers are connected. You can select PLII Movie (default), PLII Music, or PLII Game.
1
Receiver
Press the [Receiver] button followed by the [Setup] button. The main menu appears onscreen.
2
Enter
Use the Up and Down [ ]/[ ] buttons to select �3. Decoder Setup,� and then press [Enter]. The Surround Setup menu appears.
Menu -----------------------Basic Setup Setup 3.Decorder 1.Initial Setup -----------------------2.Speaker Setup 1.Analog/PCM 2.Dolby Digital Advanced Setup 3.DTS 3.Surround Setup 4.D.F.2ch 4.Audio Adjust 5.Multiplex 5.ListeningInput Preset 6.Multich Mode 6.Preference
3-2. Dolby Digital
These settings apply to Dolby Digital input signals. â� a. LFE Level With this setting, you can set the level of the LFE (Low Frequency Effects) channel for Dolby Digital sources to â��â��, â��10 dB, or 0 dB (default). If you ï¬�nd that the low-frequency effects are too loud when playing Dolby Digital sources, set this to â��10 dB or â��â�� dB.
Enter
3
Enter
Use the Up and Down [ ]/[ ] buttons to select the menu items, and then press [Enter].
Enter
4
Enter
Use the Up and Down [ ]/[ ] buttons to select the settings, and use the Left and Right [ ]/ [ ] buttons to set them. The settings are explained below.
5
When you�ve �nished, press the [Setup] button. The setup menu closes.
Note: � This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.
56
|
|
|
> |
|