INTEGRA DTC-9.4
Manual de Usuario

Listening to Radio Broadcasts
Tuner
�
CONT

+
MUTE LIGHT

+
CH

�

Tuner
VOL

L

FM Mode

Tuning

/

One of the features of the DTC-9.4 that is most frequently used is its ability to play FM and AM broadcast radio stations. The DTC-9.4 provides a number of listening modes perfect for listening to the radio and getting the most out of your audio system. Also, by presetting radio stations that you listen to frequently, you can select them easily by pressing the CH +/� button on the remote controller. When using the remote controller, select AV Amp in the Home menu to display the operation menu.

Listening to a stereo radio station (FM mode)
When you tune into a radio station, TUNED indicator appears in the display. If you tune into an FM station in stereo, then �FM STEREO� appears. If the signal is weak, it may be impossible to tune into the station in stereo. In such a case, press the FM Mode button on the front panel. The AUTO indication disappears and the radio station is output in the monaural mode. To return to stereo, press the FM Mode button again. �AUTO� appears. Some interstation noise may be heard, but the sound will not cut in and out as it would if stereo was selected.
FM Mode

Tuning into a radio station
1. Press the Tuner input source button. Each time you press the Tuner button, the input source changes between AM and FM.
DTC-9.4
Tuner

Remote controller

When using the remote controller, you can also use the FM or AM button on 4/4 page of the AV Amp pages.

2. Using the Tuning

and

buttons

Tuning

on the front panel, tune into the station you desire.
Auto mode Tuned in stereo

Band

Frequency

�FM STEREO� (Lights red)

� The tuner frequency changes in 100-kHz increments for FM and 10-kHz increments for AM. � You can press the Tuning or button continuously for more than 0.5 seconds to scan for an FM station in the direction of the button you pressed (FM auto tuning mode). After you release the button and a station is received in stereo, the scanning stops.

36