ONKYO DSR-4.8
Manual de Usuario

Before Using the DVD receiver
Installing the Batteries Using the Remote Controller
To use the remote controller, point it at the DVD receiver�s remote control sensor, as shown below.
Remote control sensor DVD receiver

1

To open the battery compartment, press the small hollow and slide off the cover.

Approx. 16 ft. (5 m)

2

Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment.

3

Put the cover onto the remote controller and slide it shut.

Notes: � The remote controller may not work reliably if the DVD receiver is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the DVD receiver. � If another remote controller of the same type is used in the same room, or the DVD receiver is installed close to equipment that uses infrared rays, the remote controller may not work reliably. � Don�t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. � The remote controller may not work reliably if the DVD receiver is installed in a rack behind colored glass doors. Keep this in mind when installing the DVD receiver. � The remote controller will not work if there�s an obstacle between it and the DVD receiver�s remote control sensor.

Notes: � If the remote controller doesn�t work reliably, try replacing both batteries. � Don�t mix new and old batteries, or different types of batteries. � If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. � Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion.

11