Before perform the camera system adjustments, check that the specified values of �VIDEO SYSTEM ADJUSTMENTS� are satisfied. Note 1: Taken an extreme care not to destroy the liquid crystal display module by static electricity when replacing it. Note 2: Set the LCD BRIGHTENSS (SET UP setting) to the NORMAL.
[Adjusting connector] Most of the measuring points for adjusting the LCD system are concentrated in CN706 of the SY-77 board. Connect the Measuring Instruments via the CPC-9 jig (J-6082393-C). The following table shows the Pin No. and signal name of CN 903. Pin No. 1 2 3 4 5 6 7 8 9 Signal Name N. C. N. C. N. C. REG_GND CPC_IN N. C. HSY PANEL_COM VG Pin No. 10 11 12 13 14 15 16 17 18 Signal Name HI UNREG LANC IN LANC OUT N. C. N. C. N. C. N. C. N. C. N. C.
Note 1: Don�t use the 12 pin flexible board of CPC-9 jig. It causes damage to the unit. Note 2: The old CPC-9 jig (Parts code: J-6082-393-B) cannot be used, because it cannot operate the adjusting remote commander.
