No hay comentarios de productos.
3.1.5 Remove the switching regulator board (See figure 9) � Prior to performing the following procedure, remove the top cover. (1) Disconnect the card wire from connector CN5301 on the switching regulator board. (2) Disconnect the socket wire from connector CN5303, CN5305, CN5306, CN5307 on the switching regulator board. (3) Disconnect the power cord from connector CN5001 on the switching regulator board. (4) Remove the two screws G attaching the switching regulator board. (5) Four spacers are removed.
Spacer Spacer Spacer Switching CN5303 CN5301 CN5307 regulator board
CN5306 Spacer
G CN5305 Fig.9
CN5001 G Power cord
3.1.6 Remove the main board (See figure 10, figure 11) � Prior to performing the following procedure, remove the top cover, drive unit, digital board, switching regulator board, HDD. (1) Disconnect the card wire from connector CN3001, CN3002, CN4001, CN7301 on the main board (2) Remove the two screws H attaching the main board. (3) Remove the seven screws I attaching the rear panel with main board.
CN4001
CN3002
H
CN3001
H
CN7301 Main board Fig.10 Rear panel
I
Fig.11
1-10 (No.YD027)
|