JVC DR-MH200SEF
Manual de Usuario

TIMER RECORDING

EN

49

Automatic Satellite Programme Recording (HDD Deck Only)
This function allows you to automatically record a satellite programme which is timer programmed on your external satellite receiver. Connect a satellite receiver to the unit�s [L-2 IN/ DECODER] connector and programme the timer on the satellite receiver. The unit starts or stops recording by the signals input from the satellite receiver. After recording, the unit�s power shuts off automatically. ATTENTION: � Be sure not to turn on the satellite receiver before the programme is executed; otherwise, the unit will start recording when the satellite receiver�s power is turned on. � If you have connected another appliance other than a satellite receiver to the [L-2 IN/DECODER] connector, be sure not to engage the Automatic Satellite Programme Recording mode; otherwise, the unit will start recording when the connected appliance�s power is turned on. � Automatic Satellite Programme Recording and timer recording cannot be done at the same time.
HDD

� Make sure the satellite receiver is connected to the unit�s � Programme the timer on the satellite receiver. � Slide the TV/CABLE/SAT/DVD switch to DVD.

[L-2 IN/DECODER] connector.

1 2 3 4

Set AL-2 SELECTB to ASAT VIDEOB or ASAT S-VIDEOB. (A pg. 65) � Also refer to AIMPORTANTB on page 68. Press REC MODE repeatedly to set the recording mode.

Press HDD to choose the recording deck.

Press and hold SATj for about 2 seconds to engage the Automatic Satellite Programme Recording mode. ASATjB appears on the front display panel. NOTES: � To disengage the Automatic Satellite Programme Recording mode, press SATj. � If the unit�s power is off, it is not possible to engage the Automatic Satellite Programme Recording mode. � In step 4, if ASATjB blinks quickly on the front display panel even though your satellite receiver�s power is off, Automatic Satellite Programme Recording will not work properly with that satellite receiver*. If this is the case, perform AManual Timer ProgrammingB (A pg. 47) to timer record a satellite programme.
* Some satellite receivers output signals even if the power is off. Automatic Satellite Programme Recording is not possible with those satellite receivers. � ASATjB blinks on the front display panel while Automatic

Satellite Programme Recording is in progress.
� For timer programming of the satellite receiver, refer to the

instruction manual of the satellite receiver.
� Automatic Satellite Programme Recording is not possible if your

satellite receiver does not have a timer.
� If there are more than one satellite programmes you wish to
CABLE/SAT TV DVD

HDD

record with Automatic Satellite Programme Recording, it is not possible to set different recording modes for each programme. � Depending on the type of satellite receiver, the unit may not record a slight portion of the beginning of the programme or may record slightly longer than the actual length of the programme. � If you engage the Automatic Satellite Programme Recording mode when the satellite receiver�s power is on, the unit will not start Automatic Satellite Programme Recording even though ASATjB blinks on the front display panel. When the satellite receiver shuts off once and is turned back on again, the unit starts recording. � You can also record a programme from your cable system in the same way if the system has a timer. � Just Clock (A pg. 77) does not work when the Automatic Satellite Programme Recording mode is engaged.

REC MODE

SAT#