3.1.3 Remove the mechanism assembly (See figure 4) � Prior to performing the following procedure, remove the top cover. � There is no need to remove the front panel assembly. (1) Disconnect the socket wire from connector CN5303 on the power supply board. (2) Disconnect the card wire from connector CN2201 on the module board. (3) Remove the four screws C attaching the mechanism assembly.
Mechanism assembly Module board C C
CN2201
C
CN5303
Fig.4
C
Power supply board
3.1.4 Remove the module board (See figure 5, figure 6) � Prior to performing the following procedure, remove the top cover. (1) Disconnect the card wire from connector CN2201 on the module board. (2) Remove the four screws D attaching the module board. (3) Lift the module board up, and remove it. Then, the module board is removed from the connector CN4104 on the DV terminal board and the connector CN4101 on the main board. In attaching the module board, insert the connector on the module board in these connectors securely.
Module board D
D
D
CN2201 Fig.5 Module board DV Terminal board CN4104
