TOSHIBA D-R150SB
Manual de Usuario

Recording Programming a recording (Continued)

Suggestions for the picture quality setting
� For normal recording or when you cannot decide which mode to choose Select �SP�. � When you need a longer recording time and video quality is not important Select �EP�. � To record a high quality picture Select �XP�. � To fill the disc Select �Auto.� A bit rate is calculated automatically according to the remaining volume of the disc. Some contents may not be recorded on the disc even if you select this function. This is not the function to make full use of the remaining space capacity.

Notes � The disc tray does not close automatically, even when the recording start time arrives. Set the recorder loaded an available DVD-RAM/R/RW disc beforehand. � When there is little time before a programmed recording starts, you may not be able to start another recording. � Playback pauses when a programmed recording starts. � Confirm the �DVD compatible mode� ( page 31) setting. �On (mode I)� or �On (mode II)� records main sound or sub-sound of multiplex broadcasts respectively, and does not record the other. Therefore, select �On (mode I)� or �On (mode II)� only when you record onto a DVD-R/RW disc. � When recording onto a DVD-R/RW disc, set �DVD compatible mode� ( page 31) to the desired recording sound for each timer programme. � Depending on the programme, an actual recording may continue a few minutes longer than programmed. � In the event of a broadcast delay, the next programme starts even if when the start time arrives prior to the end of the previous programme.

Adding a timer programme
1) Press EASY NAVI. EASY NAVI Main Menu appears. 2) Press / / / to select �Timer Recording�, then press ENTER. REC MENU appears. 3) Press to select a blank line, then press ENTER. 4) Press / to select the item, then press ADJUST to set the item. 5) When complete, press ENTER. 6) Press EASY NAVI to exit.
Note � While the recorder is preparing for or executing a programmed recording, you cannot add a timer programme which will start within 5 minutes and 15 seconds from the current time.

Deleting a timer programme
The maximum timer programme capacity is 32. Any new programme will be rejected if the recorder is full. To enter a new programme, you must cancel an existing one. 1) Press EASY NAVI. EASY NAVI Main Menu appears. 2) Press / / / to select �Timer Recording�, then press ENTER. REC MENU appears. 3) Press / to select a timer programme you want to delete. 4) Press QUICK. Quick Menu appears. 5) Press / to select �Program cancel�, then press ENTER. Check the message, then delete the entry. 6) Press EASY NAVI to exit.
Note � You cannot delete a timer programme while another is executed.

34
D-R150SB_p023-040 34 05.7.12, 11:59 PM