1.Remove the solder of Laser Diode shorting
1-1 1-2 1-3 1-4 Connect Pickup and DVD main circuit PC board by FFC(3 pcs). Fix it with the DVD Mecha Remove the solder of Laser Diode shorting on Pickup. Connect total unit of DVD Mechanism (DVD Main PCB + Mechanism) to output terminal. PC board (NCAR7181) at CN102 and CN106
Rear View
DVDM Assy Side
Short
Open
Short SW
2. Key check mode
Press the [STOP] and [DISPLAY] keys at the same time . FL display light up, and check the FL display. To cancel this process, Please press the [STOP] and [DISPLAY] keys at the same time again.
3. Factory setting (Initial setting)
3-1 Push the power switch "ON" (Mechanical switch) 3-2 Press the [STOP] and [STANDBY ON] keys at same time, and it waits until the display of FL tube will be the display of "No Disc" from "Loading".
